Installation Guide

LR2T-SLING RACK w/Tools

Enclosed you will find everything needed for the assembly

and use of your hearth rack. Two people make assembly

and installation easier. The parts and hardware included are:

Hardware included:

4 – Hard Glides

4 – 3/8" x 5/8" Button head screws

2 – 3/8" x ¾" Button head screws

1 – 7/32" Hex Key

Components included:

2 – Upright Legs

2 – Slings

1 – Tool Bar

2 – Feet

1 – Broom

1 – Poker

1 – Shovel

See reverse side for ASSEMBLY AND INSTALLATION INSTRUCTIONS

Thank you for choosing Enclume!

Enclume racks are the ultimate quality,

design, strength and function.

WARNING: READ ALL OF THE

INSTRUCTIONS BEFORE

ASSEMBLING AND USING YOUR

RACK

If you need help, please call 1-877-ENCLUME

Enclume Design Products

24 Colwell Street, Port Hadlock, WA 98339

Phone 360-385-6100  Fax 360-385-6156

www.enclume.com

PAGE 1
LR2T-SLING RACK w/Tools Thank you for choosing Enclume! Enclume racks are the ultimate quality, design, strength and function. WARNING: READ ALL OF THE INSTRUCTIONS BEFORE ASSEMBLING AND USING YOUR RACK If you need help, please call 1-877-ENCLUME Enclume Design Products Enclosed you will find everything needed for the assembly and use of your hearth rack. Two people make assembly and installation easier.
PAGE 2
ASSEMBLY AND INSTALLATION INSTRUCTIONS Rack Assembly 1) Slip the floor glides over the ends of the legs 2) Position the two upright legs pieces over the legs so they form a square. Attach the pieces together using the four 3/8" x 5/8" button head screws. The screws should be inserted from the top, tighten screws finger tight only at this point. 3) Remove the button head screw from one side of each upright holding the sling (also known as the kindling holder). Discard the screws.