Installation Guide

LR14NT - FRONT LOADING

STORAGE RACK

Enclosed you will find everything needed for the assembly

and use of your hearth rack. Two people make assembly

and installation easier. The parts and hardware included are:

Hardware included:

8 -3/8” x 1/2" Button head Screws

6 -3/8” x 5/8" Button head Screw

4 - Hard Glides

2 - Plastic End Caps

1 – 7/32” Allen Wrench

Components included:

2 - Legs 1-Broom

2 - Leg Supports 1-Shovel

2 - Curved Connection Bars 1-Poker

2 - "U" Shaped Body Pieces

2 - Kindling Holders

1 - Tool Bar

See reverse side for ASSEMBLY AND INSTALLATION INSTRUCTIONS

Thank you for choosing Enclume!

Enclume racks are the ultimate quality,

design, strength and function.

WARNING: READ ALL OF THE

INSTRUCTIONS BEFORE

ASSEMBLING AND USING YOUR

RACK

If you need help, please call 1-877-ENCLUME

Enclume Design Products

24 Colwell Street, Port Hadlock, WA 98339

Phone 360-385-6100  Fax 360-385-6156

www.enclume.com

PAGE 1
LR14NT - FRONT LOADING STORAGE RACK Thank you for choosing Enclume! Enclume racks are the ultimate quality, design, strength and function. WARNING: READ ALL OF THE INSTRUCTIONS BEFORE ASSEMBLING AND USING YOUR RACK If you need help, please call 1-877-ENCLUME Enclume Design Products Enclosed you will find everything needed for the assembly and use of your hearth rack. Two people make assembly and installation easier.
PAGE 2
ASSEMBLY AND INSTALLATION INSTRUCTIONS Rack Assembly 1) Put together legs, leg supports and hard glides. Use 4-1/2" button head screws. 2) Connect to each other with the curved connectors (curve towards the bottom) placed against the bottom of the leg units. Leave screws finger tight. Use 4 -1/2" button head screws. 3) Place "U" shaped body pieces on top of leg units, aligning holes , screw down finger tight. Use 4-5/8" button head screws. 4) Square - up rack and tighten all screws.