Instructions / Assembly

ASSEMBLY INSTRUCTIONS for the FPTS17
Rack Assembly
1) Place the arched upright on a flat surface with the two bends, which form the two front leg supports,
pointing down.
2) Attach the two back leg supports to the arched uptight opposite the front leg supports using the 1/2'”
button head screws.
3) Insert the button head screws through the front of the arched upright and into the back leg supports using the
the hex key wrench supplied.
4) Note: The screw holes in the back leg supports are threaded so they must receive the button head
screws last.
5) Square up your rack and tighten the button head screws using the hex key.
6) Hang the three tools in this set on the notches in the arched upright.
It is important that your rack is assembled correctly. If the unit is assembled or
used incorrectly, it could become unstable and collapse, possibly causing injury.
Also natural broom straw is flammable. So you must keep the broom well away
from open flame. And for sure it should not be used to sweep hot coals or ash.
WARNING
Limited Warranty: This product is warranted to be free of material defects for a period of five year from the date of purchase. The customer's exclusive remedy
shall be the repair or replacement of the defective product and shall be subject to the following conditions: (1) Customer’s written notice of any defect is received
by Enclume within the warranty period, and (2) Customer returns the defective product to Enclume Design Products,24 Colwell St., Port Hadlock, WA 98339,
postage prepaid within 20 days following customer’s receipt of a return authorization number provided by Enclume (which may be obtained by telephoning the
number above).
There are no other warranties, expressed or implied. THERE ARE NO WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR
PORPOSE. ENCLUME SPECIFICALLY DISCLAIMS ANY AND ALL INCIDENTAL OR CONSEQUENTIAL DAMAGES ARISING OUT OF THE
PURCHASE OR USE OF ENCLUME'S PRODUCTS.