Installation & Assembly

Décor Oval Rack
DR1
If you need assistance, please call 1-877-ENCLUME
Enclume Design Products
24 Colwell Street, Port Hadlock, WA 98339
Enclosed you will find everything needed for the assembly and use of your pot rack. Two people make assembly and
installation easier. The parts and hardware included are
Hardware included:
2- Ceiling Screw Hooks
2 - "S" Hooks
2 - 6 inch pieces of chain
Toggler Kit (for use in drywall)
Components included:
1- Oval Rack
1- Grid
4 - Grid Brackets
12 - Pot Hooks
ASSEMBLY AND INSTALLATION INSTRUCTIONS
1) We recommend that you anchor your rack into the solid wood of ceiling joists or beams. Carefully measure the area
where the rack is to be hung and install the ceiling screw hooks directly into the wood joists. If it is not convenient to
hang your rack directly into wood joists you may use the new-technology DRYWALL anchors enclosed with your rack.
The steel anchors are very strong and when installed in drywall will hold 200 lbs. each. Two anchors hold about 400
lbs. Follow the instructions in the Toggler kit.
2) Place the four grid brackets over the sides of the rack on the inside of each arm, with the straight end of the bracket
facing to the inside of the rack. Next, rest the grid on top of the grid brackets.
3) Using both of the "S" hooks insert one end of each "S" hook through each of the holes at the top of the rack and the
other end through one end of the chain. Place the other end of the chain over the ceiling screw hook.
4) Hang your heavier items on the straight portion of the rack body or from the center of the grid area.
WARNING: It is important that your rack is assembled correctly. If the unit is assembled or used incorrectly, it could become unstable
and collapse, possibly causing injury.
LIMITED WARRANTY: This product is warranted to be free of material defects, other than that from normal use, for a period of five
years from the date of purchase. Customer's exclusive remedy shall be the repair or replacement of the defective product and shall be
subject to the following conditions: (1) notice of any defect is received by Enclume within the warranty period and (2) customer
returns the defective product to Enclume Design Products, 24 Colwell St., Port Hadlock, WA 98339, postage prepaid within 20 days
following a return authorization number (which may be obtained by telephoning the number at the top of this instructions) being
provided to the customer by Enclume. There are no other warranties, expressed or implied. THERE ARE NO WARRANTIES OF
MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. ENCLUME SPECIFICALLY DISCLAIMS ANY AND ALL INCIDENTAL OR
CONSEQUENTIAL DAMAGES ARISING OUT OF THE PURCHASE OR USE OF ENCLUME'S PRODUCTS.