ZP19053 ASSEMBLY INSTRUCTIONS LIBERTY LATTICE OPTIONAL TABLETOP (36”W X 36”L) ASSEMBLY INSTRUCTIONS ZP19053 15 MIN Approximate assembly time Want to see a video on how to assemble this product? Scan the QR code WWW.ZIPPITY-OUTDOOR.COM WWW.ZIPPITY-OUTDOOR.COM 1 VER.
ZP19053 ASSEMBLY INSTRUCTIONS GENERAL INFORMATION IMPORTANT k Check the inside of the larger pieces in your box for other materials packed inside. k When assembling components, place on a non-abrasive surface (i.e. shipping box) to avoid scratching. k We recommend an area approximately 5’x 8’ for unobstructed assembling. k You should not need to use excessive force when assembling components.
1 3/4 in (spacing) 33 1/4 in 36 in 36 in 3 in (slat width) ZP19053 ASSEMBLY INSTRUCTIONS 39 in WWW.ZIPPITY-OUTDOOR.
ZP19053 ASSEMBLY INSTRUCTIONS STEP 1: LAY OUT MATERIALS A B Back Slat (1) ⅞” x 3” x 38¾” C 1” Self-Drilling Stainless Steel Screw (2) Slat (6) ⅞” x 3” x 38¾” D Left Frame (1) 1 1/2” x 1 1/2” x 36" 4 F G E Right Frame (1) 1 1/2” x 1 1/2” x 36” Front Frame (1) 1 1/2” x 1 1/2” x 36” 2½” Self-Drilling Stainless Steel Screw (4) WWW.ZIPPITY-OUTDOOR.
ZP19053 ASSEMBLY INSTRUCTIONS STEP 2: INSTALL THE BOARDS STEP 2.1 Identify the Left Frame (C) and lay it on a flat surface. The left frame has three pre-drilled holes on the underside of the rail. C This side up STEP 2.2 STEP 2.3 1. Insert the Back Slat (A) into the slot in the left frame under the pre-drilled hole. Insert (6) Slats (B) into the holes in the left frame until they hit the back wall. 2. Drive (1) 1” Self-Drilling Stainless Steel Screw (F) into the pre-drilled hole in the left frame.
ZP19053 ASSEMBLY INSTRUCTIONS STEP 3: SECURE THE FRONT FRAME STEP 3.1 1. Take the Front Frame (E) and position it in an L-shape relative to the left frame as shown below. 2. Drive (2) 2½” Self-Drilling Stainless Steel Screws (G) into the pre-drilled holes in the side of the left frame. E 2 1 G STEP 3.2 1. Slide the holes in the Right Frame (D) one by one over the slats until the right frame is in an L-shape relative to the front frame. 2.
ZP19053 ASSEMBLY INSTRUCTIONS STEP 4: INSTALL THE TABLETOP STEP 4.1 1. Turn your assembled tabletop over. 2. Remove the post caps from your Liberty Lattice AC Screen Kit (ZP19052) and insert the screen posts into the holes on the bottom of the tabletop. 1 2 Note: It is recommended you distribute the weight evenly across the tabletop and not surpass a weight load of 50 lbs (23 kgs). WWW.ZIPPITY-OUTDOOR.
ZP19053 ASSEMBLY INSTRUCTIONS 6935 Reames Rd. Ste. K. Charlotte, NC 28216 support@zippity-outdoor.com 704-892-5222 877-234-6196 WWW.ZIPPITY-OUTDOOR.COM 8 WWW.ZIPPITY-OUTDOOR.
