Use And Care Manual

How to remove “try me” cord:
Operation Instructions:
1) Open the battery cover and insert 3 x AA batteries (not included) into the battery
compartment.
2) Make sure to align “+” and “-“ as marked inside the battery compartment.
3) Close the battery cover and turn the switch to the “TIMER” or “ON” position and the
lights will be turned on.
4) Turn the switch to “TIMER”, the lights will be steady for 4 hours and then automatically
shut off. The lights will restart 20 hours after.
5) Turn the switch to “ON”, the lights will be steady on, turn the switch to “OFF”, the lights
will be turned off.
Trouble Shooting:
Problem Likely cause Solution
No Light
Batteries not
inserted correctly
Make sure to align the "+" and "-" as marked inside the battery
compartment
Timer is turned on Unit will restart at the end of the 20-hour cycle. To start immediately,
move the timer switch to “OFF” and then to “ON“
Batteries exhausted Change for new batteries
Disassembly Instructions
1) Turn the switch to “off” position to shut down the lights.
2) Allow lights enough time to adjust to room temperature before storing away.
3) Place in a box and store neatly in a cool and dry location protected from sunlight.
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCES
MADE IN CHINA
Step 2: Pull to unplug the jointed wires to remove the “Try me” Button.
Step 1: Pull out the try me button then open the plastic box cover