Installation Instructions

FEATURE:
For indoor & Outdoor use.
Low voltage
Steady burn lighting
Foldable metal wire Xmas tree frame with LED neon look rope light.
Sectional metal pipe trunk
Circle style metal tree stand
Metal wire with LED neon look rope light Star tree topper
ASSEMBLY
STEP 1. - Assemble trunk with tree stand
1. Put circle style metal wire tree stand on flat floor or ground.
2. Upward tapper end and straight push metal pipe trunk (1st section) into
socket at center of tree stand and then add one other trunk (2nd section)
to complete trunk and tree stand assembly. (Fig. 1)
STEP 2. - Assemble tree with trunk
1. There is a stopper (metal ring) constructed at down end of first section pipe trunk.
Pick up folded tree ( keep it folded) and settle pipe trunk on going through tree’s metal
hinge which constructed at center of tree. Push tree down till down end of hinge
touch stopper to complete this step of assembly. (Fig. 2 )
2. Unfold tree and make 2 flat tree frame into 90º cut angle. (Fig. 3)
STEP 3. - Light up tree
1. Connect power cord with adaptor. Plug male connector to adaptor and secure on adaptor.
2. Plug adaptor onto standard power electricity outlet to light up tree.
INSTALL TREE ON GROUND
Set tree on ground and hammer lawn stake into ground to secure tree on ground. (Fig. 4)
CAUTION:
1. UNPLUG PRIOR TO ASSEMBLY
2. UNPLUG IF UNUSE FOR LONG WHILE
3. BE SURE TO HAMMER EVERY LAWN
STAKE INTO GROUND AND
SECURE WITH TREE STAND.
WARNING:
1. STAY CHILD AWAY
2. DO NOT PLUG UNDER THUNDER WHEATHER
INSTRUCTIONS
Fig. 1
Fig. 2
Fig. 3 Fig. 4
1st section
2nd section