Assembly Instructions

Please read carefully before use.

1. Take out the lantern from packaging carefully.

2.Take off Try me line from try me Hole (FIG.1)

3. Locate battery compartment at the bottom of the lantern (FIG.2)

4. Use Philips style screw driver to unscrew security screw from battery compartment (FIG. 3)

5. Open compartment’s lid and put or replace with 3xAAA fresh Alkaline batteries.

6. Match the polarity of the batteries to the polarity of the compartment (FIG.4)

7. Place lid back to compartment and screw down tightly.

8. Slide switch to the “ON” position to light up lantern. It will stay on for 6 hours, then

automatically turns off for 18 hours. It will turn back on automatically after the 18 hours.

9. Slide switch to “ OFF “ position to turn light off.

Warning:

Do not place the product close to fire source. Do not place the product in water.

Replace with fresh Alkaline battery immediately when lighting intensity is weak.

Tighten screws on the battery compartment securely.

This is not a toy.

Battery operated lantern instructions

SIZE: 20 X 20 CM

FIG.1 FIG.2 FIG.3 FIG.4

PAGE 1
SIZE: 20 X 20 CM Battery operated lantern instructions Please read carefully before use. 1. Take out the lantern from packaging carefully. 2.Take off Try me line from try me Hole (FIG.1) 3. Locate battery compartment at the bottom of the lantern (FIG.2) 4. Use Philips style screw driver to unscrew security screw from battery compartment (FIG. 3) 5. Open compartment’s lid and put or replace with 3xAAA fresh Alkaline batteries. 6. Match the polarity of the batteries to the polarity of the compartment (FIG.