Assembly Instructions

SAVE THESE INSTRUCTIONS
769839-132 Page 6 of 6
If ALL of the Tree Lights are Off or Not Working:
1. Push the button on the foot pedal to turn on the lights.
2. Make sure the foot pedal connector is securely attached to the adaptor. (See Trouble Shooting Instructions)
3. Make sure the adaptor is plugged into a 110V-125V AC outlet.
4. Make sure the outlet has power (check to see if any switches or timers control the outlet) and not connected
to a dimmer switch.
5. If used on a timer controlled outlet, make sure the timer is rated for use with compact fluorescent bulbs (CFL
bulbs) or LED bulbs, if not, use on a different circuit/outlet.
STORAGE
WARNING: Make sure the tree adaptor is removed from the wall outlet or any other receptacle before starting.
1. Remove all ornaments and decorations from tree.
2. Gently lift off Top Section (A) and disconnect the lights by loosening the collar the two connectors and pulling the
female plug from the male plug, then lift off Middle Section (B) and repeat same steps to disconnect the two
connectors, and finally remove the Bottom Section (C) from the tree stand.
3. Carefully place the tree and stand in its carton and tape shut.
DO NOT STORE TREE IN A DAMP AREA OR IN AN AREA WHERE THE TEMPERATURE EXCEEDS 100° F.
FLAME RETARDANT
PRINTED IN CHINA