Assembly Instructions

CAUTION!
THE BULB MAY BE HOT. BE CAREFUL WHEN HANDLING
ALWAYS USE A PIECE OF TISSUE WHEN TOUCHING THE BULB.
INSTRUCTIONS FOR REPLACING BULB
Before you start:
REMOVE ADAPTER FROM OUTLET AND ALLOW BULB TO COOL DOWN
Diagram 1: Take the tree out of the base. Remove the 3 or 4 screws located on
the bottom of the base.
Diagram 2: Remove the base plate.
Diagram 3: Place the cover on a flat and dry surface and raise the bulb protection
ring. Carefully pull out the old bulb and only replace it by a LED bulb of
12V 3W, PUSH-IN TYPE (see chart on front side). Make sure the
bulb is correctly installed.
Diagram 4: Replace the base plate and screws. Make sure all 3 or 4 screws are
properly tightened.