Instruction Manual

5
KX3 Touchscreen Installation Instructions
KX3 Touchscreen
INSTALLATION INSTRUCTIONS
ELECTRICAL CONNECTIONS
KX3 Touchscreen Wiring Diagram
To Additional Wired Managers
(As Needed)
Power Supply
100 — 240 VAC,
50/60 Hz, 1.8A
SSU
External PoE Switch
120 VAC, 60 Hz, 10 W
(Non-Emergency Circuit)
120 VAC, 60 Hz, 300 W
Emergency Circuit (Preferred)
Non-Emergency Circuit (Acceptable)
Ethernet Cable with PoE
91.4 m (300 ft) maximum (Typical)
Ethernet Cable
91.4 m (300 ft) maximum
(Typical)
Wired Manager
To secure LAN Port for
PC Lighting Control
(Requires Static IP Address)
Note: The maximum run from the network switch
to any end device is 91.4 m (300 ft). The PoE Injector
does not extend the length limitation.
KX3
Note: A PoE Switch can be used. This will eliminate
the need for individual PoE Injectors.
CONTROL
Ethernet Port Wiring
The Ethernet (LAN) connection enables communication with a control system and power-over-Ethernet (PoE). When
powering the KX3 using PoE, a 802.3af Compliant class 3 PoE switch must be used.
CONTROL ETHERNETRS-232 (2)RS-232 (1)