Troubleshooting guide

NovaJet 800 Series Printer Quick Start Guide
42
Examine the registration + in the Current Heads Test Pattern. If they
are in register, your calibration is correct. If not, perform the following
steps to align the printer heads.
2 Examine the Horizontal Head-to-Head test pattern and select the
number that represents the best color alignment for each color.
3 Press Utility Menu/Color Calib Menu/Horizontal.
4 Select the stall (4,3,2,1,Y,M,C) for the color you wish to adjust.
5 Enter the number that represents the best horizontal color alignment.
6 Repeat for each color.
Paper axis calibration
Choosing Utility Menu/Calibration Menu/Paper Axis Test lets the printer
draw a set of vertical marks to calibrate the paper axis. To measure the marks
laid down by the printer, you will need a ruler or scale at least 33 inches (838.2
mm) long. (CD#2 of the System CD set contains a ruler file than can br printed
on your printer.) The vertical marks should be exactly 33.00 inches (838.2 mm)
apart. If the distance between the marks is different from that shown on the
display, you may adjust the printer by setting its values to match the length or
width you measured. Note: The Paper Axis Test should be performed
every time new media is loaded.
➪ To print the Paper Axis calibration test pattern
1 Load the printer with media that is at least 36 (91 cm) inches long (or
the media that you are going to run; you cannot load a 36" sheet and
then run the calibration from a roll feed because the line lengths will
not match).
2 Press Utility Menu/Calibration Menu/Paper Axis Test.
The printer prints two marks.
3 Remove the media from the printer and measure the distance
between the marks. The distance between the marks should be
exactly 33.00 inches (838.2 mm).
4 If the measurement is not exactly 33.00 inches, select "Paper Axis"
and adjust the value to the measurement read on the scale.