User Guide

These compact message communicators allow for simple
communication, and come with built in icon holders. The Talkable ll
allows the user to record two messages. Choose between two activities
such as asking and answering questions (e.g. yes, no). It has 10
seconds of recording time on each side and two output jacks to activate
two devices. The Talkable lll allows for three 5-second messages, three
jacks allow you simultaneously activates a toy or device for immediate
reinforcement, and the Talkable lV allows for four 5 second messages
with four jacks to operate devices. All the Talkables come with clear
covers. Size for II: 7½" x 4½" x 3". Requires 4 AAA Batteries Size for III:
10½" x 5" x 2¾". Talkables IV
Size: 14"L x 5½"W x 2¾"H
Requires 4
AA Batteries.
Operation:
1. Carefully turn unit over and remove the small screw from the battery
compartment. Slide the battery compartment cover off. Observing
polarity, install four AA size batteries (Not included) into the holder.
Replace cover and screw. For Talkable 2 you must install 4 AAA
batteries. Alkaline batteries must be used only (e.g. Duracell or
Energizer brand). Do not use rechargeable batteries or any other
type of batteries because they supply lower voltage and the unit will
not perform properly.
2. Never mix brands, types or old and new batteries together. Replace
the battery compartment cover and replace the screw.
3. Turn the unit on by turning the ON/OFF/VOLUME knob located on
the bottom panel of the unit. To record, first press and hold the red
“RECORD” button press down one of the colored plates. While
continuing to hold the plate down, speak your message. Release
both when you finish recording. Record on the remaining plates in the
same manner.
4. To play back your message, press lightly on the plate of your choice.
It is not necessary to continue holding the plate down when listening
to the message. The unit will continue to playback the entire
message, even if pressure on the plate is released.
5. The unit will retain recorded information indefinitely, even if the
batteries are disconnected. Previously stored information will be
erased only when a new recording is performed.
6. Playback volume can be adjusted using the “ON/OFF/VOLUME”
control knob located on the bottom panel of the unit.
To use as a switch:
7. This unit can also be used to activate switch adapted toys or devices.
Simply attach the toy or device to the corresponding 1/8 inch female
jack using the cords provided. There is an output jack for each or the
switch plates. When the plate is pressed, the message will play and
the toy or device will be activated. Make sure all connections are tight
with no gaps between plug and device.
8. The Talkables have two locations for placing Icons or Pictures. On
the back of the unit there is a holding strip where Icons or Photos can
be placed. There is also a removable clear cover on the built in round
switch plate which icons or photos can be placed. When inserting
icon in the back holding strip, insert your icon by starting at one side
of the strip. Put the icon in at a slight angle for easy installation. See
figure on back page.
Please Note: When using the holding strip if you’re Icons, Photos or
words are printed on regular printer paper, we recommend laminating
them. If not they will not stand upright or be secure in the holding strip.
Troubleshooting:
Problem: The unit fails to operate, or operates incorrectly.
Action #1: Make sure there is no dirt or obstacles between the plates
and the housing of the unit.
Action #2: Disconnect the power by removing one of the batteries for 20
seconds in order to reset the unit. Re-install the batteries. If the unit does
not work correctly, replace all the batteries.
Problem: My toy/device connected to the Talkable does not work.
Action #1: Make sure there are no gaps between your cord connections.
Action#2: Try your toy/device with another switch you know works to
rule it out as the source of the problem.
Care of the Unit:
The Talkables can be wiped clean with any mild household multi-
purpose, non-abrasive cleaner and disinfectant. We recommend Simple
Green, which is a non toxic biodegradable all-purpose cleaner.
Do not use abrasive cleaners, as they will scratch the surface of the
unit.
Do not submerge the unit, as it will damage the electrical components.
Rev 8/3/2022