User`s guide

A3 Installation
A3.4 Electrical connections
The diagram in Figure A11 shows the electrical connections in the system.
Figure A 11 Electrical diagram.
SHUTTER OVERRIDE
FIBER OPTICCAME RA
IN OUT
AUX
121
1
2
2
Red LED goes out
whenever cable
#1 is connected
correctly
Power cord
Power cord
Connect green
ground wire to
microscope
ground
Shutter
override
interface
Shutter
interface
• Connect the controller to the multiple outlet strip. The computer should
not be plugged into the outlet strip.
• Run the camera cable between the camera and the controller.
Always make sure that the controller is switched off when installing or
removing this cable.
UltraScan User’s Guide Reference Series Rev 1.0 XV