User`s guide

A3 Installation
Note that temperatures lower than 20 °C may result in condensation
accumulating in the CCD camera head electronics. This may interfere with
normal functioning of the camera.
Connect line 1 to the pressure regulator end of line 2.
Connect line 2 (flow meter end) to line 3 and the other end of line 3 to
the water inlet on the camera head.
Connect one end of line 4 to the water outlet on the camera head and
the other end to line 5 to complete the loop.
The quick disconnect fittings automatically seal the lines off when not
connected to anything, so that they may be connected and disconnected from
the camera without affecting the flow of cooling water to the diffusion pump.
Figure A 10 Water lines
UltraScan User’s Guide Reference Series Rev 1.0 XIV