User`s guide

Camera Configuration
Figure 2-3 (a) Camera Menu (b) Camera configuration
• Select Configure Camera in the Camera menu (Figure (2-3a).
• In the Camera configuration dialog box (Figure 2-3b), you can change
the name of the camera by typing in the Name field.
• Image rotation can be specified in the Rotation pull-down menu.
• The coordinates for column defect correction are entered in the Defects
field. For example, entering the following:
r0-8, r4088-4095, c0-8,c4088-4095
(r and c indicates row and columns respectively) corrects for the 8
pixels wide edge which does not contain active CCD pixels in the case
of the UltraScan 4000.
• It is important to specify the Primary and Alternate (if there is one set
up) shutter available to the camera.
• Finally you should specify the shutter status, i.e. the state of the shutter
when the CCD camera is not acquiring any images. Shutter Normally
Closed is the default setting.
UltraScan User’s Guide Reference Series Rev 1.0 2-4