User`s manual

Logging Data 6-5
December 2003
Entering Data Log Parameters (cont.)
1. Entering a Log Name
At this prompt, you may enter a new log name or choose to
overwrite an existing log.
• To set up a new log entry, use the alphanumeric keys to enter a
file name (up to five characters) and press [ENT].
• To view or alter an existing log, use the [←] [→] keys to view
all the log names and press the appropriate feature key to make
a selection.
2. Entering a Log Message
Enter a brief description (up to 21 characters) of the log. Since the
TransPort can run up to 20 logs, this message in conjunction with
the log name helps you distinguish one log from another.
3. Selecting Log Units
Use the appropriate feature key to select the measurements to log.
You can select any three measurements available on the display,
including diagnostic parameters. Use the [←] [→] keys to view
the options. At the prompt, “1st value logged,” press the
appropriate key to enter a particular measurement. Follow the
same procedure for the second and third values logged.
4. Selecting a Circular Log
The next prompt will ask “Is log circular?”
• Press [F1] to answer no, or
• Press [F2] to answer yes.