User`s manual
Logging Data 6-3
December 2003
Entering the Log Menu
To access the Log Menu, press the [LOG] key. The screen should
appear similar to that shown in Figure 6-1 below. The indicator
box shows you are at the beginning of the Log Menu. Refer to
Appendix D, Menu Maps, Figure D-3 for a flow diagram of the
LOG Menu.
Figure 6-1: Screen After Pressing the LOG Key
The Log Menu consists of the following options:
• STD - which enables you to enter parameters for the data
logger.
• MEM - which enables you to view how much memory is
available and how much memory is needed for the current
programmed logs.
• STOP - which enables you to stop logging data.
• ERROR - which enables you to log error data.
Use the appropriate section that follows to set up and use the data
logger.
LOG Start
LOGGING
Standard Log
STD MEM STOP ERROR