User`s manual

Displaying Data 4-13
December 2003
Displaying the Signal
The TransPort has a feature in the Display Menu that enables you
to graphically display the transducer signal. This feature aids in
troubleshooting transducer and other problems.
To display the transducer signal, do the following:
1. Press the [DISP] key.
2. Press the [←] [→] keys until “SIGNL” appears, then press
[F1].
The screen appears similar to that shown in Figure 4-7. The Y
axis represents the amplitude of the signal; the X axis represents
the time in microseconds.
Figure 4-7: Signal Format
51 36.750 us
S
U
P
ST:33.000 micro
<CURS CURS> <PAGE PAGE>

Y Axis
Cursor
X Axis
Status
Line
Message Line