User`s manual

December 2003
4-12 Displaying Data
Using the Graph Log Format (cont.)
Note: Since the time displayed on the status line will only show
whole minutes and not seconds, if you selected a time
increment less than 1 minute, the time will not change
every time you press the cursor key. For example, if you
chose a 5-second increment, you will have to press the
cursor key 12 times before the time changes.
Use the [←] [→] keys to access the other viewing options. Each
option is described below.
• START - This feature key automatically moves the cursor to
the beginning of the page. In addition, the TransPort displays
the start date and time of that page on the message line (see
Figure 4-6).
• END - Conversely, this feature key automatically moves the
cursor to the end of the page and displays the end date and time
on the message line.
• YMAX - This feature key displays the Y axis maximum (full
scale) chosen when setting up the graph (as described in the
previous section). The TransPort displays the Y axis maximum
on the message line.
• T INC - This feature key displays the time increment chosen
when setting up the log (as described in the previous section).
The TransPort displays the time increment on the message
line.
• EXIT - This feature key lets you exit the Log Format and
return to the default Big Format. When you exit to the Big
Format, the TransPort displays site measurements, not logged
data.
Note: To re-enter the log format on exiting, you must set up the
graph as described on page 4-10.