User`s manual

December 2003
3-42 Programming Site Data
Entering Signal Limits (cont.)
5. Entering the Low Limit for Velocity
Enter the acceptable low limit for the velocity.
• Press [ENT] to accept the current value (the default is
-40.0 ft/s), or
• Use the numeric keys to enter a new value and press [ENT].
Acceptable values are from -100 to 100 ft/s.
6. Entering the High Limit for Velocity
Enter the acceptable high limit for the velocity.
• To accept the current value, press [ENT]. The default is 40.0
ft/s.
• Use the numeric keys to enter a new value and press [ENT].
Acceptable values are from -100 to 100 ft/s.
The E3: VELOCITY RANGE error message appears if the
calculated velocity exceeds either of these limits.
7. Entering the Acceleration Limit
Enter the acceptable acceleration limit for detecting cycle
skipping. The default is 15.0 ft/s.
• Press [ENT] to accept the current value, or
• Use the numeric keys to enter a new value and press [ENT].
Acceptable values are between 0 and 100 ft/s.
The E6: AMPLITUDE ERROR message appears if the velocity
changes by more than this limit from one reading to the next.