User`s manual

Programming Site Data 3-39
December 2003
Entering Setup Parameters
The SETUP option contains four sub-options that enable you to
set signal limits, response time, and decimal digits for each site,
or to initialize the setup parameters to their default values.
To enter the SETUP option, use the [←] [→] keys to scroll until
“SETUP” appears on the screen, then press [F3]. The screen
appears similar to Figure 3-9. Refer to Appendix D, Menu Maps,
Figure D-1L for a flow diagram of the SETUP option.
Figure 3-9: Screen After Pressing SETUP Key
The Setup Menu has the following four sub-options:
• SIGNaL - enables you to set the limits and other parameters
that are used to evaluate the transducer signal.
• AVeRaGe - lets you select a response time.
• DIGIT - allows you to select the digits to the right of the
decimal point for volumetric, total, power, and energy
measurements.
• INITial - lets you set all the setup parameters to their default
values.
Use the sections that follow to enter setup parameters.
SET UP
PROGRAM
SET UP
SET UP
signal
SIGNL AVRG DIGIT INIT