User`s manual

December 2003
3-14 Programming Site Data
Entering Parameters for Clamp-On Transducers
If you are using clamp-on transducers, the following prompts will
appear:
• Wedge Temperature Input (for medium or high temperature)
• Pipe Material
• Pipe O.D. (pipe outside diameter)
• Pipe Wall Thickness
• Lining (material and thickness)
• Tracking Windows
• Fluid Type
• Reynolds Correction Factor (and Kinematic Viscosity)
• Calibration Factor
• # of Traverses
• Transducer Spacing
2C. Entering the Input Temperature
If you are using medium to high temperature transducers, you
must select whether the input is active or fixed. If not, proceed to
Step 3C: Entering the Pipe Material on the next page. Use the
appropriate feature key to respond.
• Press [F1] for an active input, or
• Press [F2] for a fixed input.
If you choose to have a fixed input, the TransPort prompts you to
enter a temperature for the transducer wedge that allows
correction of the wedge sound speed for temperature. Enter the
approximate temperature and press [ENT].