User`s manual

December 2003
3-12 Programming Site Data
Entering Pipe Parameters
The third option in the Program Menu is PIPE, that enables you
to enter information for the pipe characteristics and the
transducers. You must enter these parameters in order to operate
the TransPort. These parameters were also discussed briefly in
the Quick Start Flow Measurement Guide supplied separately.
The series of prompts that appear depend on the type of
transducers you are using. The first prompt asks you to enter the
transducer number that is engraved on the head of the transducer.
This number signifies the type of transducer: wetted or clamp-on
(standard or medium/high temperature). When you enter the
transducer number, the TransPort recognizes the type of
transducer and proceeds to ask you for the needed pipe
information for that transducer type.
This section describes how to enter pipe parameters for all
standard transducer types. If you are using a special transducer
and need to enter pipe parameters, refer to Appendix A. Use the
steps that follow to program your unit.
To enter the PIPE option, press [F3]. The screen appears similar
to Figure 3-4. The indicator box indicates you are at the
beginning of the PIPE option. Refer to Appendix D, Menu Maps,
Figures D-1C and D1-D for flow diagrams of the PIPE option.
Note: Refer to the Liquid Transducer Installation Guide (916-
055) for additional information about transducers and
configurations.