User`s manual

Programming Site Data 3-11
December 2003
Entering System Parameters (cont.)
12.Setting the Time
The last prompt in SYSTeM asks you to set the time. You can
accept the currently displayed time by pressing [F1], or change it
as described below:
a. Press [F2] to edit the time.
b. Use the numeric keys to enter the hour.
c. Press the appropriate feature key to select AM or PM, and
press [ENT].
d. Use the numeric keys to enter the minutes, and press
[ENT].
e. Use the numeric keys to enter the seconds, and press
[ENT].
You have completed entering system parameters. You may now
do one of the following:
• Use the [↑ ] and [↓ ] arrow keys to verify or change data.
• Continue to enter data using other Program Menu options as
described in this section.
• Save the entered parameters as described on page 3-32.
• Press the [EXIT] key to begin taking measurements. If you
press [EXIT] without saving, the TransPort gives you the
opportunity to save. Refer to page 3-32 to save the site data.
If you decide to exit, you must have already programmed the pipe
parameters in order to make flow measurements.