User`s manual

Programming Site Data 3-5
December 2003
Entering System Parameters
The second option in the Program Menu is SYSTeM, that enables
you to select and enter global information for TransPort
operation. You must enter these parameters in order to make flow
measurements. (These parameters were also discussed briefly in
the Quick Start Flow Measurement Guide.) To enter the SYSTeM
option, press [F2]. The screen appears similar to Figure 3-3. The
indicator box indicates you are at the beginning of the SYSTeM
option. Refer to Appendix D, Menu Maps, Figure D-1B for a
flow diagram of the SYSTeM option.
Figure 3-3: Screen After Pressing SYSTM Key
Once you enter this menu, the following prompts will appear:
• Energy Option
• Site Message
• System Units
• Stopwatch Totalizer
• Volumetric Units
• Totalizer Units
• Power (for energy only)
• Total Energy (for energy only)
• Heating or Cooling System (for energy only)
• Flow Measurement Location (for energy only)
• Date
• Time
SYSTEM PROGRAM Start
PROGRAM
system
ENERGY OPTION
OFF
OFF ON