User`s manual

December 2003
3-4 Programming Site Data
Entering the ACTIV Mode
Note: It is not necessary to enter the ACTIV menu to operate the
PT868, as the flowmeter automatically runs in Transit-
Time mode.
The first option in the Program Menu is ACTIV, which enables
you to select the Transit-Time mode of measurement. (On a
PT868-R flowmeter, the option enables you to choose between
the Transit-Time and Transflection modes. The Transflection
option is not available for the PT868.) Refer to Appendix D,
Menu Maps, Figure D1-A for a flow diagram of the ACTIV
option. To enter the ACTIV option, press [F1]. The screen
appears similar to Figure 3-2.
Figure 3-2: Screen After Pressing ACTIV Key
Press [F1] to select Transit-Time, or your may at this time do one
of the following:
• Continue to enter data using other Program Menu options as
described in this section.
• Save the entered parameters as described on page 3-32.
• Press the [EXIT] key to begin taking measurements. If you
press [EXIT] without saving, the TransPort gives you the
opportunity to save. Refer to page 3-32 to save the site data.
PROGRAM Start
PROGRAM
status
SITE STATUS
Transit
TRANS