User`s manual

December 2003
3-2 Programming Site Data
Entering the Program Menu
To enter the Program Menu, press the [PROG] key on the keypad.
The screen should appear similar to that shown in Figure 3-1.
Refer to Appendix D, Menu Maps, Figure D-1 for a flow diagram
of the Program Menu.
Figure 3-1: Screen After Pressing PROG Key
The indicator box displays three things: the task you are
performing, which is PROGRAM; “Start”, which indicates you
are at the beginning of the Program Menu; and the pointer, which
indicates more selections. Use the [←] [→] keys to view all the
menu options in the Program Menu. The menu options are as
follows:
• ACTIVe - enables you to select the Transit Time mode.
• SYSTeM - enables you to enter time, date, measurement units,
and the energy option for each site
• PIPE - enables you to enter pipe geometry, transducer, and
fluid information.
• Input/Output - lets you enter data to set up the analog inputs
and outputs.
• SAVE - enables you to save data for each site in a file.
• RECaLL - lets you recall a particular site file.
PROGRAM Start 
PROGRAM
status
ACTIV SYSTM PIPE I/O
Indicates Top of Menu
Pointer
Task
Menu Name
Default
Selection
Menu Options