User`s manual

Programming Site Data 3-1
December 2003
Chapter 3
Programming Site Data
The TransPort has a Program Menu that enables you to enter
information that is specific to each site, such as transducer types,
installation configurations, pipe material, etc.
The TransPort requires that you enter only the system and pipe
data in order to make measurements (shown in the Quick Start
Flow Measurement Guide). Although this is all that is necessary,
the TransPort Program Menu also enables you to set up the
analog inputs and outputs, RS232 communications device, and
set up checks and limits particular to your application in order to
detect problems.
Once you have entered the necessary data, you can save it in files
and recall them for later use. The TransPort can store up to 20 sets
of site data. To clear site data, refer to Chapter 7, Clearing Data.
Note: The TransPort will not allow you to save more than 20
sets of site data.
This chapter describes how to:
• Enter the Program Menu.
• Enter system, pipe, input/output, communication, and setup
parameters using the user program.
• Save files.
• Recall files.
• Set up checks and limits for your application.