User`s manual

December 2003
G-4 Screen and Error Messages
E6: Cycle Skip,
Accel
This message appears on the message
line on the screen. This indicates that
the acceleration exceeds the limits pro-
grammed in the PROGRAM Menu
SETUP option. Refer to page 10-4.
E7: Analog Out
Error
This message appears on the message
line on the screen. Current or voltage is
over the limit. Refer to page 10-4.
E8: TEMPerature
INput SUPPLY
This message appears on the message
line on the screen. Supply temperature
input is out of range. Check cable and
transmitter. Also, refer to page 10-4.
E9: TEMPerature
INput RETURN
This message appears on the message
line on the screen. Return temperature
input is out of range. Check cable and
transmitter. Also, refer to page 10-4.
End Time must
exceed Start Time
by 5 min.
This message appears when in the LOG
Menu. Enter an end time that is at least
5 minutes later than the start time.
EPROM sum =
XXXX
This message appears at power-up. It is
a good idea to record the EPROM sum
periodically just in case problems arise.
We recommend that you record the
EPROM sum the first time you power
up the TransPort.
FRIGID_INIT
Executed
The NVR was automatically initialized
due to memory fault. Consult the fac-
tory
Illegal Pipe C
Enter Bulk C
This message appears while in the
PROGRAM Menu PIPE option. Pipe
wall will not support Rayleigh wave
transducers. Enter the pipe sound speed.
Message Description/Action