User`s manual

Temperature Transmitter Installation E-5
December 2003
Connecting the Transmitter to the TransPort
If you are using the GE Panametrics DTR, simply plug the
LEMO connector into the ANALOG I/O connector as shown in
Figure E-1.
Figure E-1: Connection Locations
2. RETURN
PWR
RS232
ANALOG I/O
1
6
1
2
PWR
RS232
ANALOG I/O
1. 4-20mA/0-10V
1. GND(BROWN)
1. 12VDC-28VDC
ANALOG OUT
2. TX(RED)
6W MAX.
2. 16V (switched)
3. RX(ORANGE)
3. SUPPLY TEMP
4. DTR(YELLOW)
4. RETURN TEMP
5. No Connection
. (GREEN)
5. GND
6. CTS(BLUE)
XDCR
STREAMSTREAM
DOWN-UP-
1
FLOW
6. AOUT2
7. GND
8. No Connection
2
4
5
6
7
3
8
Note: If your unit has a 5-pin analog I/O connector, your unit only uses pins 1-5.