User`s manual

December 2003
A-2 Entering Special Transducer Pipe Parameters
Figure A-1: Screen After Pressing PIPE Key
1. Entering the Transducer Number
Enter the transducer number. Because you are using a special
transducer, do the following:
1. Press [F1] to tell the TransPort you are using a special
transducer.
2. Enter a number. The TransPort allows you to use more than
one set of special transducers, therefore, assign a number from
91-99.
3. Press [ENT].
2. Selecting the Wedge Type
The next prompt asks you to select the wedge type. The TransPort
gives you three choices: Rayleigh wave, Shear wave, or wetted
transducers. Use the appropriate function key to make your
choice.
Depending on the type of transducers you are using, do one of the
following:
• If you are using Rayleigh or Shear wave clamp-on transducers,
follow Steps 3C through 15C on pages A-3 to A-11.
• If you are using wetted transducers, follow Steps 3W through
11W on pages A-12 to A-17.
PROGRAM
Pipe parameters
TRANSDUCER NUMBER
91