User`s manual

Entering Special Transducer Pipe Parameters A-1
December 2003
Appendix A
Entering Special Transducer Pipe
Parameters
If you are using special transducers, the TransPort should be
completely programmed when you receive your unit. However, in
the unlikely event that data is lost, use this appendix to properly
program pipe parameters.
The series of prompts that appear in this menu depend on the type
of special transducers you are using: wetted or clamp-on. (Refer
to the Liquid Transducer Installation Guide (916-055) for
additional information about transducers and configurations.) The
first prompt asks you to enter the transducer number. Since
special transducers do not have a number engraved on the head
(like standard transducers), you must specify it as a special and
then assign it a number between 91 and 99. Refer to Appendix D,
Menu Maps, Figure D-1D for a flow diagram of the PIPE option.
Before beginning this section, you should have entered the proper
system parameters in the SYSTeM option as described in Chapter
3, Programming Site Data.
To enter the Pipe Menu, press [F2]. The screen appears similar to
Figure A-1. The indicator box shows that you are at the beginning
of the PIPE option.
Note: If you are in RUN, press [PROG] and then [F2].