User`s manual

ManualsBrandsEnable-IT ManualsComputer equipment868

December 2003

2-2 Initial Setup

Figure 2-1: Connection Locations

Power Connections

The TransPort is powered by either a 100-120/200-260 VAC wall

mount plug-in module, or 4 internal C-size NiCad high- energy

rechargeable batteries. When you receive the TransPort, the

batteries are not charged; therefore, to make remote

measurements using the batteries, follow the instructions on page

2-4 to charge the batteries. In either case, you must connect the

power cord to the appropriate terminal as shown in Figure 2-1.

!WARNING!

To ensure the safe operation of the TransPort,

you must install and operate it as described in

this manual. In addition, be sure to follow all

applicable safety codes and regulations for

installing electrical equipment in your area.

Transducer Connections

The transducer cables connect to the TransPort with LEMO®

coaxial type connectors. Each color-coded cable should have a

collar labeled UPSTREAM or DOWNSTREAM. Make

transducer cable connections to the top of the flowmeter as shown

in Figure 2-1. Because there are various types of transducers and

installations, transducer installation is discussed separately in the

Transducer Installation Guide.

2. RETURN

PWR

RS232

ANALOG I/O

PWR

RS232

ANALOG I/O

1. 4-20mA/0-10V

1. GND(BROWN)

1. 12VDC-28VDC

ANALOG OUT

2. TX(RED)

6W MAX.

2. 16V (switched)

3. RX(ORANGE)

3. SUPPLY TEMP

4. DTR(YELLOW)

4. RETURN TEMP

5. No Connection

. (GREEN)

5. GND

6. CTS(BLUE)

XDCR

STREAMSTREAM

DOWN-UP-

FLOW

6. AOUT2

7. GND

8. No Connection