Manualshelf

User manual

ManualsBrandsEnable-IT ManualsComputer equipment865
12345678910
P a g e 8 o f 1 5 E t h e r n e t E x t e n s i o n E x p e r t s
INSTALLING THE 865 POE & EXTENDED ETHERNET KIT
The Enable-IT 865 PoE & Extended Ethernet Kit have a distance restriction of 2,500ft or
762m over 3-pair of Category 3 up to 4-pair Category 5e / CAT6 wiring from y o u r L A N
a n d p o w e r s o u r c e to the remote PoE device. Therefore quick, simple site surveys and
installation planning are highly recommended – T h i s i s i d e a l f o r i n s t a l l i n g P o E I P S e c u r i t y
c a m e r a s o r P o E W i F i A c c e s s P o i n t s .
This chapter describes the recommended installation process for the Enable-IT 865 PoE
& Extended Ethernet Kit. It covers the following topics:
• Site Plan – Installation Design Considerations
• Unpacking the Enable-IT 865 PoE & Extended Ethernet Kit
• Perform an out of the box Test
• Performing the On-Site Installation
Site Plan - Installation Design Considerations
The planning process should involve a site walkthrough and discovery survey. Electrical
Cable measurement tools are the most reliable method to determine the longest run of
hidden wiring. Estimate the best locations to position the Broadband Concentrators to
adequately reach desired connectivity on each floor. Document your findings to use in
designing a network topology to support the Ethernet Switches and backbone
connectivity. Key points to remember in the Site Survey.
• Total distance limitation of 2,500ft / 762m from end to end. -
1,500ft/458m distance if using the PoE power for a PoE device.
• 3 Pair CAT-3 wiring or 4-pair Cat5e .30 Gage or better cabling is required for the
865 Interlink transmission.
• Cisco PoE single line injector support built in. Not compatible with any PoE
switches as the PoE switches are not smart enough to understand Extender
Ethernet timing mechanisms and fail to set correct output voltage and will
subsequently disable the PoE switch port.
• Transparent to single line 802.3af PoE injectors and devices.
For CAT3 wiring (3-pair/6wires) you will need to crimp a RJ-45 Male Head to each
end of the contiguous wire run and using the following pins(1,2,4,5,7 & 8) straight
through. This will deliver 1 Voice line, Ethernet Data and PoE.
For CAT5e or better wiring (4-pair/8wires) you will need to crimp a RJ-45 Male Head
to each end of the contiguous wire run and using the following pins(1,2,3,4,5,6,7 & 8)
straight through. This will deliver Dual Voice lines, Ethernet Data and PoE. This can
be either T-568A or T-568B spec.