Operating instructions

LED indicators will provide visual operational status of the 865 PRO units.

Mode – Yellow Solid LED

Off = CO unit

On = CPE unit!

Sync – Green slow to fast flicker LED on power up – indicates negotiation of a link

– Green solid LED indicates link established and rapid pulse is traffic!

Act – Yellow LED

Off = No device attached or detected

On = Solid, indicates the presence of local LAN

On = Blinking, indicates the presence of local LAN traffic!

Power – Green Solid LED indicates the unit is receiving 12V power

Performing the On-Site Installation

After removing the Enable-IT 865 PRO PoE Extender Kit from the box, and performing the Out

Of The Box Testing (OOTBT), all that remains to install the unit on-site is to mount the unit, build

the interconnect wiring, add voice lines if needed, and attach the LAN device cabling with the

provided Ethernet Patch cords.

Mounting the Enable-IT 865 PRO PoE Extender Units!

The Enable-IT 865 PRO extended Ethernet solution is designed for quick wall mounting.

Choose a location to mount each of the Enable-IT 865 PRO’s where the maximum distance

does not exceed 3,500ft (1,066m) total between devices to be connected. When wall-

mounting the Enable-IT 865 PRO unit it is recommended that you use the appropriate screw

anchors for your mounting surface. If mounting on existing plywood use wood screws; if

mounting onto drywall or sheetrock, use plastic drywall anchors to secure your installation.

Building the 865 PRO Interlink Wiring!

The most important aspect of the installation is the correct wiring of the Interlink cabling.

The 865 PRO Interlink port (RJ-45 interface) carries this 2-pair or more signaling over the RJ-45

(pins 1 & 2) - used as transport for 240Mbps VDSL2 data and (pins 4 & 7) - used as transport

for PoE Power. If you use more than 2-pair or more of wiring, such as a CAT5 segment, the

remaining RJ-45 pins can transport native 802.3af PoE, or are unused.

For all wiring you will need to crimp a RJ-45 Male head to each end of the contiguous wire run

and using all RJ-45 pins straight through. We recommend using a category rated twisted pair

cable as it is optimized for high throughput frequencies isolated from cross-talk noise. Insert the

completed RJ-45 ends into the 865 PRO Interlink port on each 865 PRO unit.

865 PRO CPE

865 PRO CO

RJ-45 Interlink Cabling up to 3,500 feet