User manual



Mode – Yellow Solid LED

Off = CO unit

On = CPE unit

Sync – Green slow to fast flicker LED on power up – indicates negotiation of a link

– Green solid LED indicates link established and rapid pulse is traffic

Act – Yellow LED

Off = No device attached or detected

On = Solid, indicates the presence of local LAN

On = Blinking, indicates the presence of local LAN traffic

Pwr – Green Solid LED indicates the unit is receiving 5v power

 Troubleshooting

First examine the backbone wiring pair and make sure you have solid connections. The

Interlink Sync LED will be lit solid Green with rapid pulsing on each 860 Pro unit to show

proper connection and pairing. If the Interlink Sync LED Link is flashing slow to fast and

never goes solid…. Then follow the steps below:

1) Make sure your wiring is straight through and not connected to any Telco punch

down blocks; If so remove from the block and use Telco butt clips to bridge

wire.

2) Check for a firm connection of the RJ-45 connections in each 860 Pro unit, and

power is applied to the 860 Pro CO & CPE units.

3) You can easily isolate any issue by performing an Out Of The Box Test

(OOTBT). This test will confirm the correct working order of your Enable-IT 860

Pro Ethernet Extender Kit. This will point to a possible issue with your long

distance Interlink wiring being affected by possible outside interference.

Performance Settings (DIP Switch)

If you are experiencing performance issues with your Ethernet connection you may

use the following DIP switch settings to adjust your application. For DIP switch 2-4

you must toggle both symmetrically, in other words the CO and CPE must match.

If you turn DIP switch 3 Up (Off) on the CO, then you must do so for the CPE and

vice-versa.

 Switch 1: CO / CPE Mode

CO Mode – Up / Off Position

CPE Mode – Down / On Position

Central Office Equipment (CO) is generally the equipment residing at the Carrier

Telephone office or the head end of a circuit. Customer Premise Equipment (CPE) is

generally the equipment residing on the customer side of a circuit. Typically you would

place the CO at the local end and the CPE at the remote end for reference only. CO’s

only communicate with CPE’s.

 Switch 2: Error Correction Mode

Interleaved Error Correction Enabled – Up / Off Position – degrades performance

Fast Channel – Down / On Position (Default)

Interleaved Error Correction works better for file transfers, where the delivered data must

be error free but latency incurred by the retransmission of error packets is acceptable.

Fast channel is preferred for streaming multimedia, where an occasional dropped bit is

not noticeable or acceptable.