Operating instructions

Troubleshooting!

First examine the backbone wiring pair and make sure you have solid connections. The Interlink

Sync LED will be lit solid Green with rapid pulsing on each 860 PRO unit to show proper connection

and pairing. If the Interlink Sync LED Link is flashing slow to fast and never goes solid…. Then follow

the steps below:

1) Make sure your wiring is straight through and not connected to any Telco punch down

blocks; If so remove from the block and use Telco butt clips to bridge wire.!

2) Check for a firm connection of the RJ-45 connections in each 860 PRO unit, and power

is applied to the 860 PRO CO & CPE units.!

3) You can easily isolate any issue by performing an Out Of The Box Test (OOTBT). This

test will confirm the correct working order of your Enable-IT 860 PRO Ethernet

Extender Kit. This will point to a possible issue with your long distance Interlink wiring

being affected by possible outside interference.

Out Of The Box Test (OOTBT)

Using one of the Gigabit rated CAT5e Ethernet patch cords provided, attach it to both

Interlink ports on each of the 860 PRO units.!

Attach both secure locking 12V DC adapters provided to each of the 860 PRO units and

power them up.

Both Green Sync LEDs will start flickering slowly and then fast as the units talk to each

other to calculate the optimal parameters to use for the link. After a few seconds you

should see a solid Green Interlink Sync LED on each unit to confirm a link is established.

This confirms basic proper operation of the units. Next for a more detailed test and to

confirm your LAN Equipment works with the 860 PRO, connect your Ethernet LAN and

remote device to the 860 PRO LAN ports and test connectivity. The Green Interlink Sync

LED will pulse rapidly as it detects traffic.