User manual

P a g e 9 o f 1 4
Unpacking the Enable-IT 890 Extended Ethernet Kit
Carefully remove the Enable-IT 890 Extended Ethernet Units all packing materials from
the box. Verify that the items listed below are present. Make sure that the equipment
supplied matches what you ordered. If any items are missing or damaged, please
contact your Enable-IT or your distributor for assistance.
• (2) The Enable-IT 890 Extended
Ethernet Units
o 5v DC Power adapter
o 5’ Telephone patch cable
o 5’ LAN patch cable
• Enable-IT 890 Extended Ethernet Kit
User Manual (this manual)
Performing the On-Site Installation
After removing the Enable-IT 890 Extended Ethernet Units from the box all that remains
to install the unit on-site is to mount the unit, connect the wiring, cross connect voice
lines if needed and attach the end device patch cord cabling.
Mounting the Enable-IT 890 Extended Ethernet Units
The Enable-IT 890 Extended Ethernet Units are designed for quick wall mounting.
Choose a location to mount each of the Enable-IT 890’s where the maximum distance
does not exceed 6,000ft or 1,829m total between devices to be connected.
When wall-mounting the Enable-IT 890 Extended Ethernet Unit it is recommended that
you use the appropriate screw anchors for your mounting surface. If mounting on
existing plywood use wood screws; if mounting onto drywall or sheetrock, use plastic
drywall anchors to secure your installation.
L I N E P o r t R J -1 1
L I N E P o r t R J -1 1
P i n s 3 & 4 ( c e n t e r 2 )
P i n s 3 & 4 ( c e n t e r 2 )
1-P a i r o f w i r i n g ( t w i s t e d P a i r o r t e l e p h o n e ) s t r a i g h t t h r o u g h
i r
L A N – C o n n e c t t o y o u r e q u i p m e n t
L A N – C o n n e c t t o y o u r e q u i p m e n t