Specifications

20 Gear Drive, Plymouth Ind. Park, Terryville, CT 06786
Tel: [phone] Fax: [phone] http://www.amci.com
INTRODUCTION
1
7
Other AMCI Stepper Products
The following table lists some of our other stepper products, but the line is constantly growing so the list may
be incomplete. For the latest information on all of our products, browse through our website www.amci.com.
Table 1.2 AMCI Stepper Products
Model
Number
Product
Type
Description
SD17040 Drive
Full Step / Half Step drive with an 170 Vdc motor bus and output current up
to 4.0Apk. The drive also has settings for Idle Current Reduction. Differen-
tial I/O supports cable lengths of up to 300 feet from indexer to drive.
SD17098IC
Indexer/Drive
Combination
Programmed over ControlNet or an RS-232/485 port, the unit is a microstep-
ping drive with an 170 Vdc motor bus and output current up to 9.8Arms.
With other drive specifications similar to the SD17063 Rev. B, this unit also
has an integral indexer that accepts commands from the ControlNet or serial
ports. Designed to save the cost of a seperate indexer module for applications
that are already using ControlNet or a multi-drop serial link, the indexer sup-
ports blended move profiles as well as velocity mode programming.
3202
ControlLogix
Module
Two channel stepper indexer module for the ControlLogix backplane with
incremental encoder position feedback. Featuring blended move profiles and
profiles based on encoder feedback, the module also has multiple inputs for
homing and over travel protection.
3204
ControlLogix
Module
Four channel stepper indexer module for the ControlLogix backplane. Fea-
turing blended move profiles, the module also has multiple inputs for homing
and over travel protection.
SM23-“x”
Size 23
Motors
Size 23 stepper motors that are available in 1, 2, or 3 stack configurations.
Other options include double shafts and/or integrated optical encoders for
position feedback. Go to Appendix A, CHOOSING YOUR MOTOR, start-
ing on page 45 or www.amci.com for a complete listing of available motors.
SM34-“x”
Size 34
Motors
Size 34 stepper motors that are available in 1, 2, or 3 stack configurations.
Other options include double shafts and/or integrated optical encoders for
position feedback. Go to Appendix A, CHOOSING YOUR MOTOR, start-
ing on page 45 or www.amci.com for a complete listing of available motors.
SM42-“x”
Size 42
Motors
Size 42 stepper motors that are available with double shafts and/or integrated
optical encoders for position feedback. Go to Appendix A, CHOOSING
YOUR MOTOR, starting on page 45 or www.amci.com for a complete listing
of available motors.