Specifications
Table Of Contents
- General Information
- About This Manual
- CHP 1: Introduction to the SD17063
- CHP 2: Specifications
- CHP 3: SD17063 Switch Settings
- SD17063 Worksheet
- Choosing Your Motor
- Location of Programming Switches
- DIP Switch Settings
- Self Test
- CHP 4: General Installation Guidelines
- CHP 5: Installing the SD17063 Rev. B
- APX A: Choosing Your Motor
- APX B: Upgrading to the SD17063 Rev. B
- APX C: Troubleshooting
20 Gear Drive, Plymouth Ind. Park, Terryville, CT 06786
Tel: (860) 585-1254 Fax: (860) 584-1973 http://www.amci.com
CHOOSING YOUR SETTINGS
3
19
DIP Switch Settings (continued)
Figure 3.3 Motor Switch Settings
Idle Current
Reduced to 0%
Idle Current
Reduced to 50%
Idle Current
Not Reduced
Idle Current
Not Reduced
–4% Third
Harmonic
or SELF TEST
-6% Third
Harmonic
or SELF TEST
-10% Thrid
Harmonic
or SELF TEST
Pure Sine
Output
IDLE CURRENT
REDUCTION
OUTPUT
WAVEFORM
12345
SB2
O
N
12345
SB3
O
N
12345
SB4
O
N
CW / CCW
Step &
Direction
Anti-Resonance
Enabled
Anti-Resonance
Disabled
Normal
Inertial Load
Low
Inertial Load
Typical
PULSE
TRAIN INPUT
ANTI-RESONANCE
ENABLE
*
ANTI-RESONANCE
PHASE
CURRENT LOOP
GAIN
CURRENT
CONTROL
12345
SB1
O
N
Reduced 1
Reduced 2
Reduced 3
RMS Current
Peak Current
Motor Settings
Switch Blocks 1 & 2
= Not Used When Setting Feature
*
Anti-Resonance must be DISABLED for Self Test to work.