Operating instructions



Performing The On-Site Installation

After removing the Enable-IT 860 Pro Ethernet Extender Kit from the box, and performing

the Out Of The Box Testing (OOTBT), all that remains to install the unit on-site is to mount

the unit, build the interconnect wiring, add voice lines if needed, and attach the LAN device

cabling with the provided Ethernet Patch cords.

 Mounting The Enable-IT 860 Pro Ethernet Extender Units

The Enable-IT 860 Pro extended Ethernet solution is designed for quick wall mounting.

Choose a location to mount each of the Enable-IT 860 Pro’s where the maximum

distance does not exceed 6,000ft (1,829m) total between devices to be connected.

When wall-mounting the Enable-IT 860 Pro unit it is recommended that you use the

appropriate screw anchors for your mounting surface. If mounting on existing plywood

use wood screws; if mounting onto drywall or sheetrock, use plastic drywall anchors to

secure your installation.

 Building The 860 Pro Interlink Wiring

The most important aspect of the installation is the correct wiring of the Interlink cabling.

The 860 Pro Interlink port (RJ-45 interface) carries this 1-pair signaling over the RJ-45

(pins 1 & 2) - used as transport for both voice and data. If you use more than 1-pair of

wiring, such as a CAT5 segment, the RJ-45 (pins 3 & 4) are used for voice line 2, and the

remaining pins (4,5,7 & 8) can transport native 802.3af PoE, or are unused.

For all wiring you will need to crimp a RJ-45 Male head to each end of the contiguous wire

run and using the following (pins 1 & 2) straight through. This will deliver 1 voice line, and

Ethernet data. If you desire to use the second voice line, you will need to request our

optional dongle that will allow for connecting telephone lines to this interlink wiring. Insert

the completed RJ-45 ends into the 860 Pro Interlink port on each 860 Pro unit.

 Cabling Devices To The Enable-IT 860 Pro Extended Ethernet Kit

Attach your remote LAN device to the 860 Pro CPE unit LAN ports with Ethernet patch

cord provided. Attach your local LAN to the 860 Pro CO LAN ports with Ethernet patch

cord provided. Attach the power adapters to both 860 Pro units.

Attach your local Interlink cabling end to the 860 Pro CO unit Interlink port – Then do the

same for the remote end and plug into the 860 Pro CPE unit Interlink port. The Sync

LED’s will flicker in a sequence talking to each other until they go solid. Your equipment

should now be powered up and functioning.

LED indicators will provide visual operational status of the 860 Pro units.

860 Pro CPE 860 Pro CO