Specifications

CT1000

UNIVERSAL ACCESS CONTROL SYSTEMS

INSTALLATION AND WIRING INSTRUCTIONS

Form 77085 Rev. B 08-09-2005

ADVANCED PROGRAMMING FEATURES:

There are several advanced features which the CT1000 supports when manually configured:

DURESS ALARM: (Requires the use of a keypad) When a person is making an access attempt and wishes to set off

an alarm condition he/she can set off a “duress alarm” condition by pushing any keypad button within three seconds

of entering a valid access credential (including a code, card, or iButton.) Once this is done, the alarm relay will change

state and remain in such a state until a manual reset is given, either by a valid access credential, or by a REX input

(provided that the rex input is configured to clear an alarm condition - see dipswitch settings p. 3.) Note: when using

this feature it is important to train staff in the use of the feature to prevent false alarms and effectively provide the

added security.

DOORBELL FUNCTION: The doorbell function will change the state of the AUX relay for one second anytime the *

key is pressed. This can be used to sound a buzzer to alert someone inside that someone is at the door. (Best if used

with a sign which informs the guest that the * button is a doorbell.

LAMP FUNCTION: The lamp function will change the state of the AUX relay for 5 seconds anytime any of the keypad

buttons are pressed. The AUX relay is generally used in this case to light an otherwise dark entry whenever keypad

activity is detected. This feature could also, however, be used to alert security personnel of activity at a keypad.

REX INPUT CONFIGURATION: The request to exit input can be configured to activate the MAIN or the AUX relays or

both, depending on the requirements of the system. Note that the REX input can also be configured to clear or not to

clear an alarm condition (see dipswitch settings on p.3)

HOW TO CONFIGURE ADVANCED PROGRAMMING FEATURES:

A simple manual programming step is required to configure the above advanced features. Simply follow the steps out-

lined below:

1. ENTER A MASTER PROGRAMMING CODE/iBUTTON/CARD (wait for LEDs to stop flashing)

2. PRESS 7 9 9 * (wait for LEDs to stop flashing)

3. DURESS: ENTER 1 or 0 (1 = enable 0 = disable)

4. DOORBELL ENTER 1 or 0 (1 = enable 0 = disable)

5. LAMP ENTER 1 or 0 (1 = enable 0 = disable)

6. REX - MAIN ENTER 1 or 0 (1 = enable 0 = disable)

7. REX - AUX ENTER 1 or 0 (1 = enable 0 = disable)

7. ENTER *

END OF SEQUENCE

IMPORTANT NOTES!

1. If both DOORBELL and LAMP functions are enabled, the default will be that LAMP function is enabled.

2. If the REX - AUX function is enabled, the lamp and doorbell functions will not be enabled.

3. COMPUTER PROGRAMMED codes/cards/iButtons which are configured to activate the AUX relay will NOT disable

the doorbell or lamp function.