Specifications

CT1000

UNIVERSAL ACCESS CONTROL SYSTEMS

INSTALLATION AND WIRING INSTRUCTIONS

Form 77085 Rev. B 08-09-2005

KEYPAD/100CAB INITIALIZATION (REQUIRED TO ENABLE KEYPAD TO FUNCTION WHEN

USING THE THREE-WIRE 100CAB ADAPTER CABLE):

It is necessary to initialize the keypad/100CAB any time that the memory is erased.

A. Open the cover of the controller.

B. Press the “INI” button three times (the red LED will come on and stay on (TR80/TR81 or keypads with 100CAB will

do nothing.)

C. PRESS EACH BUTTON ON THE KEYPAD, IN ORDER, STARTING WITH THE 1-2 BUTTON AND ENDING AT

THE * BUTTON. DO NOT PRESS ANY BUTTON MORE THAN ONCE.

* Wait for LEDs to stop flashing before touching pushing next button.

* Waiting for longer than 30 seconds will terminate initialization.

D. When you are finished, press the INI button once. The red LED will turn off.

TEP3/CIP Creating a Master iButton/Card (For Computer Programming):

A. Open the cover of the controller.

B. Press the “INI” button three times (the red LED will come on and stay on

(TR80/TR81 or keypads with 100CAB will do nothing - they only have a green LED.)

C. Touch Master iButton to reader (or swipe the Master card) . The LED(s) will flash to

indicate acceptance.

D. When you are finished, press the “INI” button once. The red LED will turn off.

NOTES:

1. Refer to instructions included with the programmer/software that you will use to program for more

information regarding programming.

2. The Master iButton or card is used for initiating programming. It will not unlock the door.

3. When a master programming credential is created, all factory default codes will be deleted.

PROGRAMMER INITIALIZATION TEP1 AND TEP2

The TEP1 and TEP2 programmers are intended to simulate a keypad and are required to manually

program iButtons or Cards using a TouchEntry only device. It is necessary to initialize the TEP1 or

TEP2, and master iButton or Card, any time that the memory is erased.

A. Open the cover of the controller and set dipswitch

B. Press the “INI” button three times (the red LED will come on and stay on (TR80/TR81 or iButton

readers used with 100CAB will do nothing.)

C. Enter a master iButton or card.

D. PRESS EACH BUTTON ON THE KEYPAD, IN ORDER, STARTING WITH THE 1-2

BUTTON AND ENDING AT THE * BUTTON. DO NOT PRESS ANY BUTTON MORE

THAN ONCE.

* Wait for LEDs to stop flashing before touching pushing next button.

* Waiting for longer than 30 seconds will terminate initialization.

E. When you are finished, press the INI button once. The red LED will turn off.

TEP2

TEP1