Specifications

CT1000
UNIVERSAL ACCESS CONTROL SYSTEMS
INSTALLATION AND WIRING INSTRUCTIONS
5
Form 77085 Rev. B 08-09-2005
770CAB
(KP70+ & TR83/84)
* 100CAB or
TR80/81 CABLE
WHITE
BLACK
RED
GREEN
BLUE
VIOLET
YELLOW
ORANGE
* BROWN
RED
WHITE
BLACK
PINK
TAN
GREY
<GREEN>
<BLUE>
WHITE
WHITE/BLACK
WHITE/BROWN
WHITE/RED
WHITE/ORANGE
WHITE/YELLOW
<GREY>
<BROWN>
<BLACK>
<VIOLET>
<RED>
<ORANGE>
<YELLOW>
BLACK
RED
GREEN
WHITE
VIOLET
CR90/CR91
CARD READER
PX95 PROX CARD
READER
Make connections to the access control device or adapter cable as required. Be sure that all
wiring is correct before power is applied. If more than one card reader or prox card reader must be
wired, a CR2 adapter board will be required. Refer to the instructions included with the adapter
board for special wiring instructions.
NOTES:
*1. 100CAB must be ini-
tialized to function with a
keypad.
2. Only one 100CAB
adapter cable can be
wired. Two keypads can
be connected to a single
100CAB.
3. Two TR80 or TR81
touch readers can be
wired in parallel.
NOTES:
*1. New 770CAB adapter cables
are shipped with the brown wire
clipped. It is not necessary to
connect it.
NOTES:
1. All 15 wires shown must
be connected on the CR90
models.
2. On CR91 models connect
the 9 wires which are
<bracketed> to the terminals
shown.
NOTES:
1. The PX95 requires the use of
device which has programming
ports for programming by com-
puter or a keypad for program-
ming manually. Use connection
information for appropriate
device as shown in addition to
information above (usually, a
770CAB with a keypad or
TouchEntry Key reader). There
will therefore be two wires on
some terminals. This is normal.
TB5 TB5TB5 TB5
TB6 TB6TB6 TB6