Specifications

Chapter 2: Web Configuration

Illustrations contained in this document are for representation only.

Advanced

This page allows you to configure the data rates and Wi-Fi thresholds.

54g

Network Mode:

There are three modes for you to choose, please check the specification of your wireless

card and choose a proper setting.

54g

Protection:

Select Auto to turn on the 54g

protection; select Off to turn down the protection.

Xpress

Technology:

When Xpress is turned on, aggregate throughput (the sum of the individual throughput

speeds of each client on the network) can improve by up to 27% in 802.11g-only networks,

and up to 75% in mixed networks comprised of 802.11g and 802.11b standard equipment.

Click Enabled to start this function; choose Disabled to close this function.

Afterburner

Technology:

When enabled, the data transmission will be faster for the clients. Yet, the clients must

support 125Mbps throughput, then you can choose Enabled. Otherwise, choose Disabled.

Rate:

It decides the speed of data transmission. There are several rates provided here for you to

choose. Choose any one of it according to your needs by using the drop-down menu.

Output Power:

This setting decides the output power of this device. You may use it to economize on

electricity by selecting lower percentage of power output.

Beacon Interval:

Set the period of beacon transmissions to allow mobile stations to locate and identify a BSS.

The measure unit is “time units” (TU) of 1024 microseconds.

DTIM Interval:

The value you set here is used to inform mobile stations when multicast frames that have

been buffered at the Residential Voice Gateway will be delivered and how often that delivery

occurs.