User manual

P a g e 1 0 o f 9 3
Se t u p P r o c e d u r e
8. Select the desired Wireless Access Point.
9. Click the Set IP Address button.
10. If prompted, enter the user name and password. The default values are admin for the User Name, and
password for the Password.
11. Ensure the IP address, Network Mask, and Gateway are correct for your LAN. Save any changes.
12. Click the Web Management button to connect to the selected Wireless Access Point using your Web
Browser. If prompted, enter the U s e r N a me and Password again.
13. Check the following screens, and configure as necessary for your environment. Use the on-line help if
necessary.
The later sections in this Chapter also provides more details about each of these screens.
• Access Control - MAC level access control.
• Security Profiles - Wireless security.
• System - Identification, location, and Network settings
• Wireless - Basic & Advanced
14. You may also wish to set the admin password and administration connection options. These are on the Admin
Login screen accessed from the Management menu. See Chapter 6 for details of the screens and features
available on the Management menu.
15. Use the Apply/Restart button on the menu to apply your changes and restart the Wireless Access Point.
S e t u p i s n o w c o mp l e t e .
W i r e l e s s s t a t i o n s m u s t n o w b e s e t t o m a t c h t h e W i r e l e s s A c c e s s P o i n t . S e e C h a p t e r 4 f o r d e t a i l s .
S e t u p u s i n g a W e b B r o w s e r
Y o u r B r o w s e r m u s t s u p p o r t J a v a S c r i p t . T h e c o n f i g u r a t i o n p r o g r a m h a s b e e n t e s t e d o n t h e f o l l o w i n g b r o w se r s :
• Netscape V4.08 or later
• Internet Explorer V4 or later
S e t u p P r o c e d u r e
B e f o r e c o m m e n c i n g , i n s t a l l t h e W i r e l e s s A c c e s s P o i n t i n y o u r L A N , a s d e s c r i b e d p r e v i o u s l y .
16. Check the Wireless Access Point to determine its Default Name. This is shown on a label on the base or rear,
and is in the following format:
SCxxxxxx
Where xxxxxx is a set of 6 Hex characters ( 0 ~ 9, and A ~ F ).
17. Use a PC which is already connected to your LAN, either by a wired connection or another Access Point.
• Until the Wireless Access Point is configured, establishing a Wireless connection to it may be not
possible.
• If your LAN contains a Router or Routers, ensure the PC used for configuration is on the same LAN
segment as the Wireless Access Point.
18. Start your Web browser.
19. In the Address box, enter HTTP:// and the Default Name of the Wireless Access Point
e.g.
H T T P : / / S C 2 D 6 3 1 A
20. You should then see a login prompt, which will ask for a User Name and Password.
Enter admin for the User Name, and password for the Password.
These are the default values. The password can and should be changed. Always enter the current user name
and password, as set on the Admin Login screen.