User manual

Page 8 of 14 Ethernet Extension Experts

NSTALLING THE 828 GIGABIT ETHERNET & POE+ EXTENDER

The Enable-IT 828 Gigabit Ethernet & PoE+ Extender units have an individual distance

restriction of approximately 900ft or 275m over existing Category 5, 5e or 6 wiring (All 4-

pairs required) from device extension to device extension. The 828 units can

communicate 400ft / 122m distance out each LAN port – so placing the 828 in the

middle of your run is ideal. 828 units are designed to be daisy chained in a series to

further extend distance. Up to (4) 828 units can be used in series to reach 2,000ft /

610m. Optional DIP switch setting for the last end 828 is selectable for disabling the

PoE output if installing a non-PoE powered device.

This chapter describes the recommended installation process for the Enable-IT 828

Gigabit Ethernet & PoE+ Extender. It covers the following topics:

• Site Plan – Installation Design Considerations

• Unpacking the Enable-IT 828 Gigabit Ethernet & PoE+ Extender

• Perform an out of the box Test

• Performing the On-Site Installation

Site Plan - Installation Design Considerations

The planning process should involve a site walkthrough and discovery survey. Electrical

Cable measurement tools are the most reliable method to determine the longest run of

hidden wiring. Estimate the best locations to position the 828 unit to adequately reach

desired connectivity for your overall run. Document your findings to use in designing a

network topology to support the Ethernet Switches and backbone connectivity. Key

points to remember in your Site Survey.

• Individual distance limitation of 800ft or 240m from end to end.

• Daisy Chain distance limitation of 2,000ft or 610m from end to end.

• 4 Pair CAT 5 wiring up to CAT 6 .30 Gage or better cabling is required for the

Gigabit Ethernet transmission.

Options for installation include standalone use or daisy chain configurations with the

ability to disable the PoE output. Here is a list of possible installation options:

1) Standalone 828 unit with optional 5v-2A power adapter.

2) Standalone 828 unit powered by your PoE injector or PoE switch.

3) 828P Kit with 60w-56v PoE+ injector

4) 828P Kit with 60w-56v PoE+ injector and multiple 828 units for maximum extension.

For details see diagrams of each option under the Installation section.