User manual

Page 11 of 14 Ethernet Extension Experts

DIP Switch Settings

4 DIP Switches are provided in between Extender Output ports for setting

PoE output power on or off.

Image shown above has PoE enabled on the LAN port to the left and PoE disabled

on the right. DIP Switches 1 & 2 toggle PoE (ON / OFF) for the LAN ports adjacent

to them likewise with DIP Switches 3 & 4 which toggle PoE (ON / OFF) for the LAN

port to the right.

 For troubleshooting, first examine the backbone wiring pair and make sure you have solid

connections. The RJ-45 Input and Output port LEDs will be lit with the following

LED indicators will provide visual operational status of the 828 Extender.

Input RJ-45 Port:

Power LED - Solid Green LED (left side of RJ-45 port) indicates the

5v power source is on and good.

Input LED - Solid Yellow LED (right side of RJ-45 port) indicates

Gigabit Ethernet connectivity detected.

- No LED lit (right side of RJ-45 port) indicates 10Mbs

or 100Mbs Ethernet connectivity detected.

Output RJ-45 Port:

Gigabit LED - Solid Yellow LED (left side of RJ-45 port) indicates

Gigabit Ethernet connectivity and activity.

10/100 LED - Solid Green LED (right side of RJ-45 port) indicates

100Mbs Ethernet connectivity and activity.

- No LED lit (right side of RJ-45 port) indicates

10Mbs Ethernet connectivity.

Then follow the steps below:

1) Check for a firm connection of the RJ-45 connections in each connection

including your LAN equipment, PoE Injector and 828 Extender and power is

applied to the 828 via the PoE or optional 5v adapter.

2) You can easily isolate any issue by performing an out of the box test confirm either the 828

Extender or your wiring.

Technical Support

Enable-IT OEM Technical Support is available directly to customers and distributors. All

support requests are processed through the online support portal. This allows us to provide

assigned support ticket numbers in order to bring closure to any technical issues.

Enable -PoE

output -

DIP position 1, 2, 3, & 4 Down

(ON – PoE Output)

Default DIP settings –

Disabled PoE output

DIP position 1, 2, 3, & 4 Up

(OFF – no PoE Output)