User manual

Page 10 of 14 Ethernet Extension Experts
Option 2: Standalone 828 unit powered by your PoE injector or PoE switch.
Option 3: 828P Kit with 60w-56v PoE+ injector.
Option 4: 828P Kit with 60w-56v PoE+ injector and multiple 828 units.

Mounting the Enable-IT 828 Gigabit Ethernet & PoE+ Extender
The Enable-IT 828 Gigabit Ethernet & PoE+ Extenders are designed for quick wall
mounting. Choose a location to mount the Enable-IT 828 where the inline midpoint
is no further than 400ft / 122m from your source Ethernet LAN and destination
endpoint. When wall-mounting the Enable-IT 828 Gigabit Ethernet & PoE+ Extender
it is recommended that you use the appropriate screw anchors for your mounting
surface. If mounting on existing plywood use wood screws; if mounting onto drywall
or sheetrock, use plastic drywall anchors to secure your installation.
 Before applying power, determine if your end device requires PoE power. The default
DIP switch setting has PoE output Disabled. To enable PoE output change the DIP
switch position to ON – DOWN position.
Depending on distance you can safely power PoE devices requiring 6v to 48v.
Attach your cabling and devices and apply power. Your equipment should now be
powered up and functioning.